The solar insecticidal lamp is the main plant protection product of Henan Yunfei in 2015. Solar insecticidal lamps are widely used in agriculture, orchards, forestry, etc. Although they are widely used, they are not clear about the installation, wiring, hanging lamps, etc. of insecticidal lamps. Today we will talk about solar insecticidal lamps. Installation layout and overhead hanging lights.
1, the layout of the insecticidal lamp
There are two ways to layout: one is a chess-like distribution, and the other is a closed-loop distribution. Generally, in the actual installation process, the chess-like distribution is more generally applicable. Because it hangs the line in the wild and then pulls the branch road to Daejeon, it is convenient to maintain and repair. There are also users who use other distribution methods according to the actual situation in the actual installation, which should be adapted to local conditions. Regardless of the method used, the control area should be calculated with a single lamp radiation radius of 120 m to achieve energy-saving pest control.
2, wired
According to the type of lamp selected, choose a 220V or 380V power supply, and then use a straight overhead line (the position of the pole is best matched with the layout of the lamp). Where there is no pole, use a pile of more than 2.5m as a temporary pole, and never pull the line anywhere to prevent accidents.
3, power requirements
The voltage fluctuation range of each lamp is within ±5% of the mains. If the lamp is too high or too low, the lamp will not work properly. If the power supply used is 220V, it is far away from the transformer, and the number of lights per line is more. To reduce power fluctuations, it is best to use three-phase four-wire or single-phase one-ground wiring. Connect the lights in the line to each phase line evenly so that the lights can start working normally. In addition, the total road knife and branch knife should be installed in the line to hang lights and maintain.
4, hanging lights
Determine the position of the lamp, plant two wooden stakes or tripods, and fix the rings on the lamp on the crossarms of the two pegs with wire. The height 31 is 1.3~1.5m (the distance to the ground of the insects). To prevent the lamp from swinging back and forth when the wind blows, the lamp housing should be pulled on the two piles with two wires, and then the wiring should be tightly wrapped with insulating tape. Pay special attention when the copper wire and the aluminum wire are connected to each other to prevent moisture. Oxidation causes poor contact and prevents the lamp from working properly.
Roasted Buckwheat Flour,Toasted Buckwheat Flour,Organic Buckwheat Bread Flour,Health Buckwheat Bread Flour
Huantai Biotechnology Co., Ltd. , https://www.huantaifds.com