1. The engine is cleaned with water under medium-speed operation and the dirt should be completely removed. Do not stop operation immediately after cleaning, but continue to turn for 2-3 minutes. (subtitle - Caution to prevent water from entering the air filter)
2. Open the front cover, close the fuel filter, release the oil from the oil pipe, install the oil pipe after discharge is completed, and loosen the oil discharge bolt of the carburetor, and completely release the gasoline in the carburetor so as not to oxidize and rust in the carburetor. Blocked.
3, in order to prevent the cylinder wall and valve rust, open the spark plug, to inject new oil into the cremation plug hole about 20ml, check the spark plug, if there is carbon deposition, remove with sandpaper, the electrode gap can be adjusted in 0.6-0.7mm mm, Install the spark plug, pull the starter around 10 turns; install the front hood.
4. Connect the main clutch, slowly pull the recoil starter, and stop at the position where there is compression.
5. In order to prolong the life of the pressure spring of the planting arm, the planting fork should be kept at the lowest position (pressing the seedling).
6. The main clutch handle and the planting clutch handle are “disconnectedâ€, the oil pressure handle “fallsâ€, and the signal light switch is in the “stopped†state.
7. The cleaned rice transplanter should be covered with a hood and stored in a place where there is no dust, less moisture, and no direct sunlight, to prevent wind and rain, and sunlight.
The above describes the use and maintenance of hand-held transplanters. Machine transplanting can be not limited by region and variety, and has the advantage of popularization and application on a large scale. It is an important way to increase rice land productivity and labor productivity.
Medical Ear Thermometer,Ear Thermometer,Infrared Ear Thermometer
Dongguan Keyutai Mask Co., Ltd. , https://www.maskkytai.com