Before shelling and soaking the beans, remove the shell with stone.
Soak the beans and then soak the beans with cold water. The water is 10 to 17 cm above the bean surface. Soaking beans for 2 to 2.5 hours in spring and summer, and dipping beans for 3 to 4 hours in autumn and winter, do not use warm water to dip beans.
Grinding bean grinding beans can be used electric grinding or stone grinding, only need to grind once, when the grinding edge of the water, put the beans, or put the beans together, put 15 to 20 liters of water per 7.5 kg.
When boiling the pulp, the water is boiled first, and 17.5-22.5 liters of water is burned per 7.5 kilogram of beans. After the water is boiled, put a spoonful of soymilk into the boiling water until it is finished. The ground soybean milk is boiled in 15 minutes. The fire must burn vigorously. The milk must be boiled three times before it is ripe. For each boiling, stir once with a spoon, try not to stir it up for the first time, and stir it up for the second time.
Filter and filter twice, filter once with mosquito net cloth, then filter with sanitary gauze, filter it and put it on bamboo.
The filtered bamboo milk is placed on all the yuba trays. The yuba is placed on the yuba stove and the steam is used to heat the bamboo. When the bamboo is blown, the bean husk should not be capped. The fire is moderate, and the soybean milk surface wrinkle cloth Full can be pumped up and pumped every 5 minutes. When bringing the bamboo, he took the yuba head in one hand and the yuba in the other forefinger and took it gently from the beginning to the end. The yuba was pulled symmetrically and placed on a pre-prepared bamboo raft. The bamboo raft was hung on top of the yuba. After one full one is replaced with another one, and the sun is exposed to the sun in a timely manner. When the sun is dry to fifty-six percent, the yuba will be removed, and then dried on the floor or bamboo mat.
IT02S, is JRT new product in the early 2019, which is a single-point LiDAR sensor, also called tof distance sensor. With a micro size of 46x17x7mm, customers can widely use in many Laser Measurement Solutions. The lidar distance sensor can measure 12m short-range with high frequency up to 100hz. It's great for Unmanned Aerial Systems. If you need us send you data sheet and spec for this products, offering sample as well, pls tell us, thank you.
Accuracy
+/-8cm@ 0.1~3.5m
Measuring Unit
cm
Measuring Range (without Reflection)
0.1-12m
Measuring Time
0.1~3 seconds
Measuring Frequency
100 Hz
Laser Class
Class II
Laser Type
650nm, <1mw, red
Weight
About 5g
Voltage
DC2.5V~+3.5V
Serial Level
TTL 3.3V
Size
46*17*7mm
Operating Temperature
0-40 ℃ (32-104 ℉ )
Storage Temperature
-25~60 ℃ (-13~140 ℉)
IT02S Mini Tof Sensor Module Diagram
Parameters of IT02S:
IT02S – the High performance-price ratio measurement solution
* low power consumption of single transmit and single receive
* small size: 46*17*7mm
* low cost
* proffessional techinical support
2D Laser Distance Sensor,2D Lidar Sensors,Tof Lidar Distance Sensor, Flight Distance Sensor
Chengdu JRT Meter Technology Co., Ltd , https://www.irdistancesensor.com