How to suppress tractor tilting head

Posted on

When the tractor begins to tilt forward slightly, the front wheel will lift off the ground. At this moment, you can press the clutch pedal. Let the front wheel gently touch the ground again and immediately apply the brake. If the tilt is more significant but there's no immediate danger of tipping over, you should quickly press both the clutch and brake pedals at the same time. This will stabilize the tractor at that height. Then shift into neutral, close the throttle to stop the engine, and slowly release the brake pedal while simultaneously letting go of the clutch. As the front wheel lowers to the ground, make sure to press the brake again right away. **Note:** Never press the clutch without first pressing the brake. Failing to do so could cause the tractor to drop suddenly, potentially damaging the front tires or other components. If the tractor tilts forward significantly and there’s a risk of overturning, the operator should quickly lean the machine sideways to prevent the steering wheel from coming loose and to avoid being burned by hot liquid from the radiator. At the same time, press the clutch and brake pedals to stabilize the vehicle. Then, close the throttle to shut off the engine. (If the engine doesn’t turn off, the oil sump may rise due to the slope, causing oil to splash.) Try to exit the seat carefully and position yourself in front of the tractor. Use the brake pedal repeatedly—pressing and releasing—to gradually lower the front wheel to the ground. Once the front wheel touches the ground, apply the brake immediately and remove some of the load if possible. After the situation is under control, perform any necessary troubleshooting and repairs.

Small 2D LiDAR Sensor

IT02S, is JRT new product in the early 2019, which is a single-point LiDAR sensor, also called tof distance sensor. With a micro size of 46x17x7mm, customers can widely use in many Laser Measurement Solutions. The lidar distance sensor can measure 12m short-range with high frequency up to 100hz. It's great for Unmanned Aerial Systems. If you need us send you data sheet and spec for this products, offering sample as well, pls tell us, thank you.

IT02S Mini Tof Sensor Module Diagram
IT02S Mini Tof Sensor Module Diagram
Parameters of IT02S:

Accuracy

+/-8cm@ 0.1~3.5m

Measuring Unit

cm

Measuring Range (without Reflection)

0.1-12m

Measuring Time

0.1~3 seconds

Measuring Frequency

100 Hz

Laser Class

Class II

Laser Type

650nm, <1mw, red

Weight

About 5g

Voltage

DC2.5V~+3.5V

Serial Level

TTL 3.3V

Size

46*17*7mm

Operating Temperature

0-40 ℃ (32-104 ℉ )

Storage Temperature

-25~60 ℃ (-13~140 ℉)


IT02S – the High performance-price ratio measurement solution
* low power consumption of single transmit and single receive
* small size: 46*17*7mm
* low cost
* proffessional techinical support

2D Laser Distance Sensor,2D Lidar Sensors,Tof Lidar Distance Sensor, Flight Distance Sensor

Chengdu JRT Meter Technology Co., Ltd , https://www.jrt-measure.com