How to maintain the electric blast drying oven

How to maintain the electric blast drying oven

 

How to maintain the electric blast drying oven

When placing the sample in the box, it should not be too dense, so as not to affect the normal flow of the airflow inside the box. There must be 15 to 30mm gap between each thing , and placed symmetrically. The things on each shelf should be placed at the same time. The distance between the plates must be greater than 100 mm from the bottom of the cabinet .

The use of this equipment must be handled by a dedicated person. When the facility is used, the external power supply should be cut off to avoid accidents.

Please strictly observe the " Product Manual " before using the facility , and then perform various operations. If you do not know the details , you can contact the manufacturer Shanghai Kailang Instrument Equipment Factory in time.  

It is not allowed to put flammable, explosive and volatile substances into the facility for dry treatment.

When storing and using the facility, there are no flammable, explosive and corrosive things around.

Do heart electrical components and disassembly facilities zero (portion) member, so as not to destroy the electrical throttle lines, human error leading to the facility and affect its performance.

Avoid sharp and sharp scratches on the facility.

A certain amount of space should be left around the facility to facilitate heat dissipation and operation and protection.

Heating refers to the light is not bright, the end is usually three: 1 light is broken; 2 light contact is not good; 3 heating system is faulty.

Explosive, flammable and volatile things should not be placed in the dry box, so as not to cause the explosion to start.

 

Every time after use, all power supplies must be cut off, often keeping the inside and outside of the box clean. After cleaning, the corresponding logo is hung.

Do not put flammable objects in the dry box of the device.

Do not over-extrude things in the box, and make sure to leave room for natural convection.

The power cord should not be disturbed on metal objects. It should not be placed in a place with high temperature or humidity to avoid leakage of rubber due to aging.

Shanghai Kailang Instrument Equipment Factory Friendly Tip: When using the power supply, avoid touching the electrical parts to the left side of the box by hand or wipe it with a damp cloth and rinse with water. The power should be cut off during inspection and repair.

Be sure to pay attention to the consistency of the power supply voltage before use. When using, be sure to ground the power outlet ground wire as specified.